Spent hours trying to install DD-WRT v2.4 onto the Linksys WRT54GS v1.1. Whatever you do, don’t do the 30/30/30 reset a second time; it will brick your router. I know. To recover, you must take out the circuit board and short pins 5&6 with a small screwdriver while plugging in the power. Within 30 seconds, you’ll need to tftp the new firmware to the device. This will get you back to working again. Make sure to use the Mini-Build required for initial flashing via TFTP. This will get you to a working router.

This entry was posted on Wednesday, April 21st, 2010 at 10:26 pm and is filed under WILT. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.